Tips for Replacing a Garbage Disposal .


At times, even the best care and maintenance can prevent a garbage disposal from breaking down. However, with proper tools, installing a new under sink grease trap is going to be more easy and stress-free. The question however is, how do you know when to replace your garbage disposal? Well, when you flip the switch to turn on the garbage disposal and all you get is a loud, metal on metal grinding sound, then you need to be aware that something is amiss. The fantastic news is that replacing a garbage disposal does not require you to have a diploma from a renowned university in Rocket Science. Even in the event that you have not done much plumbing, you will have the ability to manage it as it’s a trouble-free procedure that any patient person could successfully manage. This article is majorly likely to talk about how you need to replace your garbage disposal without the assistance of a specialist.

The very first thing you ought to do is to prepare for the job ahead of you. It’s prudent that you have all the parts listed on the instruction sheet to prevent destructions once you start the project. What follows should be turning off the power to the disposal at the circuit -breaker box. One of the most important things you should not neglect to do is to confirm the amperage off the circuit in order to be certain the disposal will not overload it. Once all that is done, you must disconnect the drain from the disposal unit with the use of pliers so as to loosen the spring clamp holding the dishwasher drain tube in place. Following that, you must remove the drain tube in the device and proceed to the next step.

Second, you should think about taking out the disposal device. The best way to do this is by twisting it from the mounting nut since you dump out any residual debris and water. What follows is that you ought to turn the device upside down with the only purpose of removing the plate covering the electric connections. After that’s done, you must remove the grounding cable and screw nuts so as to pull the cable out of the device. You should take notice that if your disposal is the same as the older device, there’ll be no need to replace the mounting hardware. If that is not the case, you will have to remove the existing mounting assembly in order to drain.

The following step should be to install the hardware whereby you will have to place a rubber seal on the underside of the drain flange. You will then have to join the mounting ring with threes screws and tighten it until the assembly is even and tight. Finally, you will have to prepare the new disposal s you complete the installation so click here.

Should you like to know more, you could visit .

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s